Jaw crusher PE600X900 for sale

Leave Message Get Quotes

Jaw crusher PE600x900 introduction

Jaw crusher PE600X900 is a middle scale stone crusher machine with feeding opening size 600x900mm. A Jaw Crusher is sized so that the maximum feed size is 80% of the gap and width openings. The gap is the measurement between the two jaw dies, while the width is the measurement between the two side plates. So PE600X900 jaw crusher is used to crush various rocks and ores with medium hardness, such as limestone, sandstone, granite, gypsum, etc which compressive strength does not exceed 250MPA, and the feed size does not exceed 500mm. It is usually used for primary crushing in stone crushing plant, mobile stone crusher plant, concrete crushing plant, quarry plant, mineral processing plant.

Features

1. It uses anti-wear high manganese with features of light weight, high strength and rigidity, low energy consumption.

2. Stone crusher PE600X900 is single-toggle type jaw crusher with advanced features for optimized performance, easy maintenance, long life and a low cost per ton.

3. It has features of a deep symmetrical crushing chamber and is easy settings adjustment; a large feed opening size, and an ideal nip angle that offers smooth material flow and high crushing efficiency.

4. We also design and provide stone crusher plant with capacity 50 t/h 100 t/h, 150 t/h, 200 t/h, 300 tph, 400 t/h, 500 t/h, 800 t/h, 1000 t/h. The solution with flowchart and price could be sent for free.

How does jaw crusher PE600x900 work?

The working principle of jaw crushers is based on the reciprocating movement of the movable jaw that compresses and crushes the rock or ore between itself and the fixed jaw, as the material enters the zone between the jaws.

Jaw crushers use compressive force to break down large materials into smaller, more manageable pieces. It has two crushing jaws (one is stationary while the other one is moving) that produces mechanical pressure for crushing the materials. The two vertical crushing jaws create a V-shaped opening called the crushing chamber where the materials are dropped off. It’s so-called because the opening starts off wide then tapers down to a V where the crushed materials go to.

Our service

People Also Frequently Asked For - FAQ

1.What is the purpose of a jaw crusher machine?

Jaw Crushers are a ompression-type machine that crush material between a moving piece of steel and a stationary piece of steel. They are used for primary and sometimes secondary size reduction.

2.How big of a rock can a jaw crusher crush?

In general, jaw crushers have a maximum feed opening size of about 48 inches by 60 inches, but the actual size of the rocks that can be crushed may be smaller or larger than this depending on the specific crusher.

3. How to select a jaw crusher?

The selection of the best jaw crusher for your application will naturally be governed by the particle size, volume, and properties of your bulk material, along with the desired particle size and quantity of the final sample.

4. How to set a gap on a jaw crusher?

Jaw crusher gap adjustment is very convenient, only need to adjust the pull rod spring behind the jaw plate, you can increase or reduce the spacing. The method can be applied to a wide range of jaw crushers, including large jaw crusher and the required material size can be achieved without expanding or reducing the size of jaw crusher.

MAYBE YOU ARE INTERESTED IN