Baichy Impact Crusher PF-1214 is used for secondary crushing middle hard stones and rocks with compressive strength less than 350 MPa such as limestone, concretes, clay, cement, calcium, granite, marble etc. The Impact Crusher PF-1214 is widely used for sand and rock production in the industry of roads, railways, building materials and so on. This type of impact crusher PF1214 is installed in Russia successfully.
Impact crusher PF 1214 Features
1. Cubic-shaped end products;
2. Adjustable end products sizes, simple crushing process;
3. The board hammer is made of high chrome and, abrasion-resistant, and with powerful impacting force;
4. Non-key connected, easy to maintain, cost-saving;
5. Sound construction and high efficiency.
Working Principle Of Impact Crusher PF 1214
The materials are crushed via impact energy produced in the impact crusher. When the materials enter the zone of the board hammer, they are flung into the impact equipments via the high-speed impact of the board hammer. These materials will be re-crushed after rebounding into the scale board. The large materials are crushed into small pieces until it becomes the specified granularities. The end products come out from the base of the impact crusher.
It is configured with a hopper, vibrating feeder ZAW9638, primary jaw crusher PE600X900, impact crusher PF1214, vibrating screen 3YK1860, and belt conveyors. The main process is as below:
1. The truck unloads the stones into the hopper, the stone enters the vibrating feeder from the lower part of the
hopper;
2. The vibrating feeder feeds the stones evenly to the primary jaw crusher;
3. The crushed output materials 0-280mm from the primary jaw crusher will be transported to Transfer silo with a vibrating feeder.
4. The crushed output materials 0-280mm in the transfer silo will be transported to impact crusher PF1214
5. The crushed output size 0-50mm from the impact crusher PF1320 will be sent to the vibrating screen 3YK1860.
6. After screening by the three-layer vibrating screen, will get 0-5mm, 5-10mm, 10-20mm, and +20mm materials. The 0-5mm, 5-10mm, 10-20mm final products will be transported out by belt conveyors to stockpiles, +20 materials will be transported to the transfer silo for re-crushing.
This crushing plant is suitable for processing many kinds of soft stones, like limestone, plaster, etc. The capacity for this
crushing plant can be customized as per request such as 200tph, 500tph,1000tph, etc
Baichy Machinery has a history of more than 20 years. It not only produces a full set of crushing and sand making equipment, but also provides EPC project general contracting services, including plant site selection and construction, production line design and installation, and production and operation technical training. Welcome to consult online to get your exclusive stone crushing plant solution.
An impact crusher can crush hard materials while a jaw crusher can crush brittle ones. A jaw crusher is suitable to use for harder rocks such as granite, basalt, ores, and concrete. On the other hand, an impact crusher will work best with clay, limestone, coal, dolomite, and other medium-hardness materials.
The main difference between an impact crusher and a cone crusher is that an impact crusher uses impact force to crush material, while a cone crusher uses pressure to crush material. Impact crushers typically use high-speed rotating hammers to crush material, while cone crushers use a spinning conical head.
Impact crushers typically require more maintenance than compression style crushers – especially if crushing hard and abrasive materials. This is because the material in an impact crusher is constantly colliding within the crusher at high velocities to break the rock apart.
2024-11-15
86-15093113821
86-15093113821
